Expander foam filling in gap between kitchen Island and wall
Fresh new look.
DONE… next job… lol
Following weekend… paint the darn thing… uh as bad as sanding. Just the top board and doors as well as the corner for the gibb edge. The fridge space should be able to take the average size fridge…
Fridge, freezer back in place, one set of shelves done.
Fridge section sealed and painted.
ummm!
Painted and smaller bench and shelves put in behind the bar.
Behind the bar
Lino laid even goes up under the sliding door and all.
Starting to stock the bar.
Just needs the rest of the balustrades
What bits where now…??? (doesn’t look level but it is… lol)
Installing the insulation.
Installing and nailing in holding nails.
Installing and nailing in holding nails.
Pink Batts over top of the original insul-fluff…
Nail plated Bourbon o’clock time.
Nail plate
Put in temporary stay pile I had to knock into place and then nail plate it in. It ain’t going anywhere… if it is then the rest of the house is moving with it and I can’t stop that :-/
I do need to tweak the angle of the roll a little for the top ramp but as you can see I don’t have a lot of room. I have about a spare 5mm to raise the angle. I can’t just lower the back as then the can won’t roll forward. Hopefully it will be enough.
It holds nine cans. If you take from the bottom the will roll the next can in. This is good for rotating your cans as the oldest then gets used.
Go to the camera and find the three pictures of Central Otago and get the them enlarged. Put in to frame and re-seal back.
Now the three pictures we took look like a bought set.
