Hulk SMASH… Robbie SMASH…
Water proofing the bar!!!
Water proofing the bar which is under a deck is a lot harder than one thinks. One has to remember that it was not designed to be water proofed in the first place else it Read More …
Year: 2012
The Greenhouse
However we did notice that the while they have all the angle braces in the various spots, they don’t actually have any on the longitude. Which means it is sturdy laterally but not the other. Read More …
drill bit shelf
Some where to store all the drill bits and pieces… Router bits shelf. I was going to put on other side of pile, but it got in the road for getting the larger bits of Read More …
Insulation
Pink Batts…”I so itchy…” Since this photo we now also have 95% covered the Pink Batts with ceiling blanket. Giving 3 layers of insulation in the ceiling. (Will eventually get a photo of the the ceiling Read More …
Not so hot now?
You said it was too hot the other week siting on the deck. We listened, and we agree… Sat out under it for a got 20 minutes in the full heat of the day… Read More …
Bosch Heat Gun
3 speed 50-600 degrees Digital read out.
Spanners & crescents
I have a range of spanners and adjustable crescents & vice grips. Some are Powerbuilt others are ratchet and yet others are just cheap ones.
Remove Old Work Bench
-
- The old work bench that was there when we bought the hose.
-
- oh is that where my spanner went… :-\ lol.
-
- where’s me table saw gone…?
-
- And has been removed ready to start the boxing for the concrete floor some time in the near future.
Router Jig
Old, just a straight edge and two clamps.
Old piece from a vacuum cleaner.
One end bolted and the other swings and clamps.
It works… 🙂 The vacuum works well (now I have a shop vac) and I have also connected the a hose to the standard router port which now it catchs 99.5% of the dust.
It now sits at the end of work bench. Fence is easily removed and the top is flush with bench increasing the work area..
